So I am going to build a water cooled build in an evolv x case. I am going to do a cpu and gpu loop, with a 360 mm and 280 mm rad. i need to figure out which fittings i am going to get, could you guys help out?
You need two fittings per component of the loop.
There, pick the fittings you want for the loop you want.
This, plus if you use some sort of a valve or splitter then more per G1/4 thread on whatever splitter you are using.
This is a question that only you can answer since you may need more than 2*numberofpartsoftheloop. It will depend on kind of tubing you are using, the color scheme, your drain plug, the size of tubing, and if you want to use any fittings in place of bends,etc
Bingo, in a nutshell, custom loop is that, very much custom with no loop the same (unless its a blatant copy) so will all have varying needs.