Description

I wanted a small gaming pc with decent airflow and sleek looking... Drilled the holes with a jigsaw and cleaned up with some filing. Might need a bit more cable management.

Couldn't be any more pleased with the result.

Log in to rate comments or to post a comment.

Comments

  • 37 months ago
  • 2 points

how is that monitor? been seeing it a lot recently.

  • 37 months ago
  • 3 points

Pretty nice, but if I were you I'd wait for the newer model, some issues might be fixed and will have a smaller better foot. Only issue I have it sometimes turns purple in certain greys, but when I turn it off and on it stays away for a while. I will send it in for repairs when I know for sure they can fix it with firmware update. But overall its a sweet monitor.

[comment deleted]
  • 34 months ago
  • 2 points

Hi! Want to use the same cooler (considering between slim and non-slim versions) for 7700 in mini-itx build (node 304 case). What about temperatures for cpu under load?

  • 34 months ago
  • 2 points

Looks awesome! What are the temps like?

  • 37 months ago
  • 1 point

Very nice, clean build.

  • 37 months ago
  • 1 point

you did a fantastic job on modding that case +1

  • 37 months ago
  • 1 point

Dang, I'm jealous of everyone who has hole saws and can successfully cut the top of these cases! I only had a hand drill strong enough to make a hole pattern and that was annoying >< Anyway, nice job! +1!!!

  • 37 months ago
  • 2 points

I did not use a hole saw, I used a jig saw that I borrowed from my dad. Wasn't perfect but did the job and took some filing and light sanding.

  • 37 months ago
  • 1 point

That's pretty impressive, they look pretty much perfect in the photos. How long did it take for you to cut the holes?

  • 37 months ago
  • 1 point

Hmm.. about 20 mins mapping out where to make the holes, 20 mins to drill and cut out as close as possible and about 1 hour for filing and cleaning up. Could easilly be done faster but I wanted it to be as good as possible.

  • 37 months ago
  • 1 point

What a sexy build~!!!!

  • 34 months ago
  • 1 point

how did you fit that gtx 1080 in :O build looks dope

  • 31 months ago
  • 1 point

fit rather well, I just had to bend the usb cables upwards

  • 33 months ago
  • 1 point

What are the temperatures like?

  • 31 months ago
  • 2 points

Both CPU and GPU (especially GPU) have plenty of air to do decent overclocking. Temps are great, comparable to a full size case if not better, air gets replaced a lot faster

  • 32 months ago
  • 1 point

Hey what are the temps with the 7700 and the Pure rock slim. cuz I wanna upgrade to an i7 but but if i get the 7700k then i would have to buy a new cooler so i might get the 7700

  • 31 months ago
  • 2 points

temps are 34°C Idle, about 60-70°C when I game, cooler is enough for 7700, for a 7700K I would advise something bigger, those cpu's tend to run a lot hotter

  • 31 months ago
  • 1 point

great to hear! thanks for the reply

[comment deleted by staff]
  • 37 months ago
  • 1 point

Top IO ports needed some cutting to bend, then I strapped a zip-ty to hold them bend upwards. Now GPU fits perfectly snug.